Bathroom cam – No matter what the economy, nobody wants to spend more than they need for repair and replacement of plumbing. If you have a leaky faucet, you do not need to replace the faucet, simply replacing the seats and springs in the bathroom faucet. Ball taps have feathers that sometimes show wear and leave you with a leak. Leaks eventually get worse and you will soon see your water bill to rise. It takes a simple kit to fix the leak and about 30 minutes of your time. Compression faucets have seats and trays that you can replace to stop the leak.
Shut the water off at the shut-off valve. You must remove the handle. Tip the handle back on the faucet and you will find the screw that holds it in place. Remove the screw using the Allen wrench. Remove the handle. The bathroom cam nut directly below where the handle base set. Use a pair of groove joint pliers to grasp the nut and rotate it until it is resolved. Do you have a Delta faucet, you should have slotted nuts using a special tool that comes with the repair kit. Peerless units have surface-to-use groove joint pliers.
Remove the CA module and you’ll see the ball assembly under. When you replace springs, replace seals on the valve and cam. Remove the ball and set it aside. Your kit may have a new one. Press the seal in the spring and then put Allen wrench through the center to slide them back into the opening with seal on top. Press the ball of the shoulder. Install new bathroom cam cover of the ball and line up key with the tap body. Tighten the cap until it is tight. Install the faucet and tighten screw.
After bathroom cam of faucet part now replacing seat of a compression crane. Turn off the water. Remove the screws on the top of the handles. Some of them hide under a plastic circular into the center. You need to pry it off with a screwdriver to access the screw. Pull the lever straight up to remove it. Turn the trunk to remove it and lift it out. Sometimes you do not replace seat but simply tray at the base of the stem. Use a seat wrench to remove the seat. Place new seat wrench and push wrench into the faucet holes. Replace the washer on the bottom of the stalk. Remove the screw, put it in the circular opening and replace the screw.